Wake on Lan setup between a wireless bridge and access point possible?

Discussion in 'Tomato Firmware' started by delajed, Jun 26, 2009.

  1. delajed

    delajed Addicted to LI Member

    I have two routers running tomato. The access point that's hardwired to my modem has tomato 1.19 (with mlppp) and the other one (with a vanilla tomato 1.23) acts a wireless ethernet bridge.

    The PC I'm trying to configure is hardwired to that bridge. The PC's hardware is WoL ready, and properly configured.

    I've tried suggestions from this past thread,


    with no success. I applied changes strictly to the access point, and left the bridge alone - the PC does stay in the WOL menu (within Tomato) after going to sleep with a "-" status. I could however easily wake it up through the same page. However, I've had no success trying to do it over the web (Depicus). I've also ensured that the IP address is proper through Dyndns.

    I was just wondering if it was possible to set up WoL through the Internet with said setup?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice