WAP11 as a Client to Freedomlink :wallbang:

Discussion in 'Networking Issues' started by r6dude, Feb 12, 2006.

  1. r6dude

    r6dude Network Guru Member


    I have a WAP11 with DWL 900AP+ firmware on it. What I would like to is connect to a FreedomLink network using the WAP11 in client more and then connect WRT54G to the WAP11.

    So the Setup is:

    PC => WRT54G(Alchemy) => WAP11(900AP+) =>FreedomLink

    What I am having trouble is to setup WAP11 as a client. I correctly set the WAP11 to connect to FreedomLink hotspot. But I am confused in terms of connecting my PC to WAP11 to check whether I can reach the Internet.

    1. What should be the IP address of the LAN port on WAP11 when the WAP11 is in Client mode?
    2. How should the PC be set in term of getting a IP address?

    Thank you.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice