Wap54g as repeater

Discussion in 'HyperWAP Firmware' started by profegarces, Aug 12, 2005.

  1. profegarces

    profegarces Network Guru Member

    Hi, do I need to upgrade my Wap54g to hyperwap firmware to work as a repeater of a WRT54G with hyperwrt?
  2. MegaByteNL

    MegaByteNL Network Guru Member

    No, the original Linksys will do. If you wish to use WPA as security you need firmware 2.08.

    Make sure you enter the mac address of the wireless part of the WRT.

    This can be found on the "Status/wireless" page of the WRT.
  3. profegarces

    profegarces Network Guru Member

    cool, thanks a lot.
  4. kiilakas

    kiilakas Network Guru Member

    Once more about repeater:
    does hyperwap gives me signal from eth interface too in repeater mode?
    Or can anyone suggest better firmware for it?
  5. sutil

    sutil LI Guru Member

    hyperwap only has a changes in wireless settings there's no problem regarding the firmware
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice