wap54g client dhcp

Discussion in 'Other Linksys Equipment' started by linedpaper, Dec 29, 2005.

  1. linedpaper

    linedpaper Guest

    I know there used to be problems with this, but thought it was better now. I am running the newest official firmware (3.04). It's a brand new wap54g, I have it setup with 128 bit wep. The clients connect with near full signal, but can't get dhcp. I should mention that my dhcp server is a m0n0wall firewall. These same computers get dhcp while plugged in, but don't over wireless. The dhcp scope is wide open, it appears that they aren't passing through the wireless at all as my dhcp logs don't show any requests for addresses. The wap54g logs show that the clients connected. Any help would be great. Thanks,
  2. Avenger20

    Avenger20 Network Guru Member

    Make sure you're gateway on the wap54g is the m0n0wall ip. Don't know about 3.04, but 2.08 works perfect with m0n0wall here.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice