WAP54G - Reset to Default IP Address Setting

Discussion in 'General Discussion' started by poslow, Feb 24, 2006.

  1. poslow

    poslow Guest

    I have just been given a WAP54G Version 2 Linksys Access Point.
    It was set up with a IP address in which the ex-owner has forgotten.
    When I used the setup Wizard, I was unable to get a connection.
    I am sure the IP address of the WAP54G is not the default 192.168.1.x
    Is there a way that I can reset the WAP54G back to its original factory setting ?
    If not, how can I find out was being setup ?

    Any advised is appreciated.
  2. howardp6

    howardp6 Network Guru Member

    Press the reset button on the back of the unit for at least fifteen seconds. That should reset the unit to factory settings. The default IP Address for the unit is and the default password is admin.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice