WAP54G v2.08 Firmware bug

Discussion in 'Other Linksys Equipment' started by Freeway, Jun 12, 2005.

  1. Freeway

    Freeway Guest

    Ever since updating my WAP54G firmware to v2.08 the status page always shows wireless security disable.

    I'm 100% sure that security is enabled since when I disable WEP on my laptop's wireless card i'm unable to get an IP from my network.

    Never had this problem with v2.07, anyone else seeing this aswell?

    P.S i'm using the WAP in AP mode, with nothing special configured. Use it to connect laptop and xbox as clients.
  2. mariquit

    mariquit Guest

    I purchased mine just yesterday and it came with a 2.08 firmware. I am unable to change the channel settings after several attempts.

    I was forced to change the firmware to Freya.
  3. cuzzindavid66

    cuzzindavid66 Network Guru Member

    CAN TINYPEAP be loaded onto the WAP54G?

    I have a WAP54G with firmware 2.08 and have tried in vain to load TinyPEAP.
    do you know if its possible to upload it to a WAP54G?

  4. oopsibrokeit

    oopsibrokeit Network Guru Member

    tinypeap is for routers only, not for access points.

    what you need is mustdie or sveasoft freya or hyperwap.

    the 2.07 firmware from linksys seems to be the most stable genuine firmware on my boxes.
  5. howardp6

    howardp6 Network Guru Member

    Did you save the settings? What AP mode are you in?
  6. HellMind

    HellMind Network Guru Member

    today my wap54g refuses too to change the channel
    dunno why

    must die (last)
  7. peter1975

    peter1975 Network Guru Member


    Sorry for asking.. but whats so good about for example must die... does it give the accesspoint a better performance???
  8. oopsibrokeit

    oopsibrokeit Network Guru Member

    mustdie gives extra features like transmit power increase and some other stuff thats pretty useful.
  9. mrgr

    mrgr Network Guru Member

    ok, so whats the solution.. witch firmware :sad:

    2 days of fighting with this chanels problemm!!
  10. bigfreak

    bigfreak Guest

    wap54g v2 (v2.08 firmware) says I can't downgrade and I notice the WAP54G firmware mods are all based on 2.07. I assume I'm just being a newb or something, but right now it's not obvious to me how I can load these firmwares on my AP. any help would be great. :)
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice