WAP54G Ver 3 Setup button

Discussion in 'Other Linksys Equipment' started by Darkvador, Oct 16, 2006.

  1. Darkvador

    Darkvador Network Guru Member

    What's the Use of the Button on the WAP54G ver3 ?
    when u pu**** , it goes white , and flashes , and after that , that's impossible to log into .
    so what's the use of it , thx
  2. Toxic

    Toxic Administrator Staff Member

    the manual explains what is is.

    Orange/White. The Cisco logo is the Access Point’s SecureEasySetup button. It lights up when the Access Point is powered on. The Cisco logo is orange when the SecureEasySetup feature is not used, while the color white indicates that the SecureEasySetup feature is being used.

    When the Access Point enters SecureEasySetup mode, the Cisco logo will turn white and start flashing. Then the Access Point will generate its SSID (network name) and WPA-Personal (also called WPA-PSK) key. If the Access Point successfully associates with a client using SecureEasySetup, the Cisco logo will stop flashing and stay white. If the association is unsuccessful, then the Cisco logo will stop flashing and stay orange.

    To clear the SSID and WPA-Personal key, press and hold down the Cisco logo for ten seconds. The Cisco logo will turn orange to indicate a successful reset.
  3. Darkvador

    Darkvador Network Guru Member


  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice