WAP54G with Sveasoft firmware

Discussion in 'Other Linksys Equipment' started by BarateaU, Jun 2, 2005.

  1. BarateaU

    BarateaU Network Guru Member

    Hello, my first post her ;)

    So i flasht my WAP54G device yesterday and i notict that when i rised the defualt signal powwah fron 28mW to 84mW my speed dropped inside the network from 2300kb/s to about 1300kb/s.


    I thougth that more signal strenght would result in more range and not loss in speed.
    And its not just a bit of speed, about 1000kb/s it mutch.

    So i put it back to 28mW becous the speed, and i notist that the net would drop very often.
    So now i use it at 84mW to not lose the connection all the time and i get 1000kb/s speed loss.

    Is this normal?
    And i read that its possible to set it to 255mW but it is not shown, right?

    Be gentel, my english is crap.
  2. HellMind

    HellMind Network Guru Member

    try 48m

    here isnt the rule the more power the more speed

    your hard got a limit, the 1.0v got a low power limit,
    you should stry 48 mw

    if u got 2.0 try more
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice