WDS Frustration - Disregard, solution found

Discussion in 'HyperWRT Firmware' started by mskreis, Feb 21, 2006.

  1. mskreis

    mskreis Network Guru Member

    I need some help trying to setup 2 WRT54GS v4 with Thibor 13d and WDS. I followed many of the recommendations here and from Thibors page but still no luck.

    WRT-A is connected to my Actiontec DSL modem. Router IP is, DHCP enabled, AP plus WDS, and wireless MAC of WRT-B entered in bridge. Both wired and wireless devices have internet access.

    WRT-B is at the opposite end of the house. Router IP is, DHCP disabled, WAN disabled, AP plus WDS, LAN gateway, LAN DNS, firewall disabled, and wireless MAC of WRT-A entered in bridge. Any device connected to this router cannot access WRT-A.

    What am I missing here?

  2. swinn

    swinn Network Guru Member

    Are both routers set to the same SSID and channel? Do you have encryption turned on and if so are both set to the exact same settings?

  3. mskreis

    mskreis Network Guru Member

    Yes, same channel and SSID. I initially tried WPA but now I'm not using any encryption to try and simplify as much as possible.
  4. mskreis

    mskreis Network Guru Member

    Disregard this post please. I found my mistake - incorrect MAC.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice