WDS+MAC filtering makes WRT54g web interface inaccessible

Discussion in 'Cisco/Linksys Wireless Routers' started by sh9998, Jun 11, 2005.

  1. sh9998

    sh9998 Guest

    I've got WDS going on two WRT54Gs using HyperWRT. It works fine, until I try to enable MAC address filtering on the wireless-only WRT54G. After that I can't access the setup web pages on that device, even if I connect a PC to it via an Ethernet port instead of using wireless.

    The MACs for the wireless computers are in the filter, and other than the inability to access the setup pages, everything else still works fine (can access the internet OK) assuming I have all the setups correct prior to enabling the MAC filtering. Only a long reset will make that web page setup accessible again, which of course, also clears all the setttings and disables WDS.

    Thanks for any ideas.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice