WDS Mash v23 RC1 mini WRT54G(S) (wds nodes) info

Discussion in 'DD-WRT Firmware' started by dirtyclyde, May 8, 2006.

  1. dirtyclyde

    dirtyclyde Network Guru Member

    DSL 6100 --> switch ---> WRT54GSv1.0 (ap-2)(thibor15b1) wds (3 nodes)
    DSL 6100 --> switch ---> WRT54GSv2.1 (ap-9)(v23 mini rc1) wds (3 nodes)
    DSL 6100 --> switch --> WRT54GSv2.1 (ap-8)(v23 mini rc1) wds (3 nodes)

    WDS --> WRt54GSv2.1 (ap-7)(v23 mini rc1) --> XBOX360 (5 nodes)
    WDS --> WRT54Gv4.0 (ap-6)(thibor15b1) --> XBOX (5 nodes)
    WDS --> WRT54Gv4.0 (ap-5)(thibor15b1) --> PC (5 nodes)

    ap-7 has five nodes wds0 = ap-2, wds1 = ap-8, wds2 = ap-9
    wds3 = ap-6, wds4 = ap-5
    wds3 & wds4 display %0 and never change (ap-6 & ap-5)

    look like when you have 5 WDS Nodes on the Wireless Status Page or Sys-info Page it will not display the bar correctly ( the last two nodes), they are 0% (no color) on dd-wrt-v23 mini rc1, thibor15b1 are correct.

    ap-2 9 & 8 point to ap-7 6 & 5 OK
    ap-6 7 & 5 point to the other 5 aps.

    Appears to be just the Status pages as they are linked correctly via wds and do work. I have powerd down different aps and the STP configures them OK after 20 to 30 secs. or so!

    WRT54GSv2.1 will not run Thibor15b1 because of the 4.71.1 linksys code, it sets clkfreq to 200MHz and drops large file transfers among other things!

    Cheers great firmware.
  2. dirtyclyde

    dirtyclyde Network Guru Member

    Sorry this does work, while looking at the info page on ap-7 dis a power down of ap-5 & ap-6 and they did display correctly just takes a while.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice