WDS with wrt54g v8 and wrt54g v2

Discussion in 'HyperWRT Firmware' started by tomaz, Sep 11, 2007.

  1. tomaz

    tomaz Network Guru Member

    I have two router , one is wrt54g v2 with hyperwrt tofu 13 and other is wrt54g v8 with the factory firmware. I need expand range of wireless. I need to make a wrt54g with hyper wrt, to be repeater of wrt54gv8.
    cable modem --> wrt54gv8 ------------ wrt54g v2 tofu <-----> wireless clients.

    It´s this possible. Because it´s too bad signal betwen wrt54gv8 and wireless clients.
    Thks in advance.
  2. HennieM

    HennieM Network Guru Member

    Don't know, but try turning on Lazy WDS on your V2, with the exact same wireless settings as the V8, and see if it connects to the V8. I know the V5.1 stock firmware does support Lazy WDS, but I don't know about the V8's firmware.
  3. tomaz

    tomaz Network Guru Member


    I try but don´t work
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice