Discussion in 'Other Linksys Equipment' started by cicero, Jul 26, 2005.

  1. cicero

    cicero Guest

    I have a WET11 bridge version 1 and it works fine. However I have decided to turn on WEP on all my devices which are Linksys, I have no problem settig up the cards in the pc and the router. But the moment I turn on WEP on the WET11 it works for a few seconds and then dies. I have to do a hard reset to get it to work again.
    Linksys support told me to upgrade the firmware which I did no change
    Any advice as to what is happening? I spent 100 bucks on this and I use it to connect three servers to my network through a swicth - but I really want to turn on WEP :oops: :oops:
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice