WET54G Stops Running. 3 different units.

Discussion in 'Other Linksys Equipment' started by lilmatty, Mar 21, 2006.

  1. lilmatty

    lilmatty Network Guru Member

    I hope this is the right topic.

    Using a WET54G, V3, f/w 1.08 connected to a 15dBm wire mesh antenna and receiving from an AP. Using the Linksys POE adapter with cat5 length 15 to 30 feet.

    Problem: WET54G works just fine for about 20-30 minutes then stops. At that point all the panel lights are flashing. Power cycling gets it running again until the next time this happens. Obviously frustrating.

    The POE has been taken out of the path and the behavior is the same. We've reflashed the f/w with no joy.

    Worst yet this behavior is displayed on 3 different WET54G setups.

    Anybody have any ideas abut what's happening here?

  2. ReelBigJosh

    ReelBigJosh Guest

    Same deal, different router

    I'm experiencing the same problem with a WRT54G v5. Upgraded the firmware to 1.00.6, but it's still giving me grief. Power-cycling fixes it for a while. I iMac G5 and one old linux box connected via ethernet, and one iBook G4 able to connect wirelessly, WPA Personal security is set up.
  3. lilmatty

    lilmatty Network Guru Member

    I just got off the phone with one of Linksys' phone guys. He wanted me to return the 3 I've got for an exchange. This, even though I mentioned several times that it sure seems like that's not the fix to the problem. And that I'd already RMAed one of them and the new one came back just the same.

  4. Axey

    Axey Guest

    I am experiencing this as well so I doubt the RMA will do anything. REALLY annoying.

    What do you have connected to your bridges? A printer perhaps?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice