What the hell is wrong?

Discussion in 'DD-WRT Firmware' started by nastronomical, Aug 18, 2005.

  1. nastronomical

    nastronomical Network Guru Member

    Ok so i just downloaded and flashed the firmware to my WRT54G .I put in the ip and it shows a page...But nothing esle.I cannot go any farther or do anything...what did i do wrong?
  2. Rich-M

    Rich-M Network Guru Member

    Possibly the 'stats' page?? look at the bottom for 'GUI interface' and click on that :)
  3. howardp6

    howardp6 Network Guru Member

    Hopefully you flashed the firmware from a wired connection and reset the router to its original default setting before you did the update. These are recommended steps, Which and whose firmware version were you on and what firmware were you updating to. Can you connect via a wired connection? What lights are on on the router? Power down the router a power it back up. If you still cannot connect reset the router to factory defaults by pressing the reset button for a least thirty seconds and try to re-establish a connection to the router again.
  4. nastronomical

    nastronomical Network Guru Member

    Ok thanks guys it worked.I chosed the client bridge option and i surveyed and found my wireless modem.How do i set it so that i use that connection?

    <my pc + wrt bridege> -------<verizon wireless modem>
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice