When did load-balancing method change for RV042?

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by compwhiz, Aug 8, 2006.

  1. compwhiz

    compwhiz Network Guru Member

    So, I am reading the manual, and it looks like there it describes that there are two ways to setup load-balancing of the links - automatic(intelligent) and manual. In the beta that I am running, there is only one way to setup load-balancing(automatic), and there is ability to do protocol binding, which seemed to be absent from previous versions, as the user guide does not mention anything about protocol binding.

    When did this whole thing change? I really like protocol binding, but I think having only one LB mode is silly, as I can't control how the traffic is being distributed. Also, my RV042 seems to be sending traffic through the link that is down(via Network Service Detection) when Load-Balance is selected. help?
  2. Toxic

    Toxic Administrator Staff Member

    this i would guess is a browser issue. either an anti virus program is blocking the page loading fully or some other setting in the browser is not fulling loading the page. when you select load balancing, a new part of the page appears with protocol binding, where you assign http, smtp, pop3 etc to an individual WAN port.
  3. steve8411

    steve8411 Guest

    Not to hijack this thread... but

    Is there a way to control wan1 / wan2 protocol binding by inbound vs outbound?

    I want to have outbound assigned to wan2 port 80 and inbound assigned to wan1 port 80
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice