Which is the most stable firmware for WRV200?

Discussion in 'Linksys Official Firmware' started by ycfd3s, Jul 19, 2007.

  1. ycfd3s

    ycfd3s Guest

    Recently, I setup a WRV200 for a wireless network. But the router is very unstable after few hours that usually can not access the web page or ping the router usually result a high (xxx ms) around 500ms~2000ms. The router will go normal if I replug the power adaptor.

    I am using a 1.0.32 firmware, and mainly use wireless connection.

    Any recommendation of firmware is the most stable?

    Thank you:wink1:

  2. ifican

    ifican Network Guru Member

    That was a problem in the early firmware but has cleared up for the most part in later releases. You could try .33 which is now out and see if it helps.
  3. woodmouze

    woodmouze LI Guru Member

    I had the same problem with 1.0.32, and was using 1.0.35 till today... it seems DYNDNS isn't really working very well - I just upgraded to 1.0.36 which seems to solve my issue using dyndns.
    1.0.35 updates dyndns every hour (even without a change)
    1.0.36 is now updated 1h15 minutes ago, so it takes at least longer than 60 minutes right now :D

    you can check your dyndns updates on : https://www.dyndns.com/account/services/hosts/auxlanglog.html
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice