"Wireless Client Filter" reversed its setting behavior

Discussion in 'Tomato Firmware' started by ggbal, Nov 4, 2017.

  1. ggbal

    ggbal Addicted to LI Member

    Tomato Firmware 1.28.0000 MIPSR2-132 K26 USB VPN

    I was adding a new MAC address to the filter list. The setting then is "Disable filter". After saving it and set it back to "permit only the following clients", all devices in this list can't get connected. Then I found out if I set it to "block the following clients" and everything worked again. I realized that now the setting just reserved its meaning - block means permitting and permit means blocking.

    I don't want to erase the nvram and re-flash it since I have many setting in this router. Any of you have experienced the same issue and how you fix it?

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice