'wl' command for enabling/disabling SSID Broadcast?

Discussion in 'General Discussion' started by AbacusSoft, Jun 22, 2005.

  1. AbacusSoft

    AbacusSoft Guest

    Hi there,

    I hope that this isn't in the wrong forum.

    Basically, could someone please tell me if it is possible to change the setting/flag for the SSID Broadcasting through the command line? It is a WRT54G router, which has the firmware upgrade (thus allowing telnet).

    I've been through the whole list of commands available through 'wl', but can't see anything that immediately jumps at me for that setting.

    Also, it took me a while figure out how to change the channel - although I had been using the corrent "syntax" for a good few hours, I didn't realise that you needed to alter another property (i.e. the SSID) before the channel setting is aknowledged - is this a bug?

    Thanks in advance for your time.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice