WOL: Wake on LAN?

Discussion in 'HyperWRT Firmware' started by xadox, Feb 22, 2005.

  1. xadox

    xadox Network Guru Member

    is there a way to wake up my pc behind the WRT or to make broadcast?

    If i try to setup the port forwarding on IP-Adress x.x.x.255 i get the message only on 0-254.
  2. Rainey

    Rainey Network Guru Member

    Using the utilities i found here http://pages.towson.edu/aczech/magicpkt/ i was able to wake the PC up from a low power state like standby or hibrnate, but not from a powered off state.

    If you are doing this from the internet then only one of the utils support that and you send the magic packet and the port number and the IP address of the PC behind the router.
  3. guardianx

    guardianx Network Guru Member

    i'm also interest in WOL via the internet but i need to forward the port to a broadcast ip which is xxx.xxx.xxx.255 . is there any firmware that will allow me to do this???
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice