WRE54G and IE issue

Discussion in 'General Discussion' started by islandskip, Jan 1, 2007.

  1. islandskip

    islandskip Guest

    I have a WRE54G setup to extend the range of a wireless signal that is radiating from a pole that has a Cisco bridge and access point installed in an enclosure. The auto configuration didn't work but I was able to configure the RE and have the two blue LED's. From my laptop I can see the RE just fine but any attempt to access the internet results in a page can not be displayed. An ipconfig shows no valid IP address. If I connect to the Cisco AP I can get an IP and access the internet. Any idea on how to solve this would be appreciated.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice