WRE54G Stops to connect to WRT54GS V1.1

Discussion in 'Other Linksys Equipment' started by lautamas, Nov 21, 2005.

  1. lautamas

    lautamas Network Guru Member

    Hello People,
    Yesterday I upgraded my WRE54G into the new firmware 1.06. After upgrading, I found weird settings and behaviour on the expander.
    1. Where can I setup manually (in WRE54G) the MAC address of my access point where it is supposed to connect? In the old firmware, I can put down manually the MAC address that I need to connect to. But in the newest firmware, there is only "LINK STATUS"
    2. Anybody happens to have the old firmware? I would go to the old firmware because it was pretty stable.
    3. The WRE54G works fine if I press the "AUTO CONFIGURATION" button. But, I dont want it to use the same SSID as my router, so...I changed it. Now, everytime I change something in the WRE54G manually, then the DHCP will not work at all. So, clients will not get an IP out of the WRE54G.

    Anybody can help me with those issues?

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice