WRT330N in bridge mode - Can it be done?

Discussion in 'Networking Issues' started by avmba, Jan 26, 2009.

  1. avmba

    avmba Guest


    I hve a WRT330N that sits behind a DLINK router/wirewall. I want to put the WRT330N into bridge mode so I can expose all of my machines to one another (most are wired into the DLINK except an Xbox 360 and a laptop).

    Any thoughts on how to do this? I can't seem to figure it out. I can get internet access OK and have turned off all firewall settings on the Linksys device but my wireless machines can't see the wired ones.

    I can't use the Linksys device alone as my structured wiring panel (where the DLINK box is) is too far away and too shielded to get good wireless coverage elsewhere. Would like to avoid buying any more equipment if at all possible.
  2. ifican

    ifican Network Guru Member

    Just use the wrt as a switch. Plug the dlink into a lan port of the wrt, make sure the wrt has a static lan ip and turn off dhcp. Simple as that.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice