WRT350N Port Forwarding

Discussion in 'Cisco/Linksys Wireless Routers' started by rileyka, Oct 9, 2007.

  1. rileyka

    rileyka Guest

    I just got a WRT350N v1 running firmware 1.03.2 to replace my WRT54G v2.2. I run my own webserver and FTP server behind this router and i have set up port forwarding on this router just like it was on my 54g but it wont forward the ports!! The settings stay there and are activated but when trying to access my webserver from my network it just tries to send me to the router configuration, and from outside my network it just times out. I know my server is good because I replaced the 54g and everything started to work again. Has any one else experienced this problem?
  2. Toink

    Toink Network Guru Member

    Is the server on Static or Dynamic IP? Did you set up DMZ?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice