WRT54g access restriction help

Discussion in 'Cisco/Linksys Wireless Routers' started by brad1138, Aug 26, 2006.

  1. brad1138

    brad1138 LI Guru Member

    I just replaced my Netgear router with a WRT54G, Huge improvement. 1 thing I liked with the Netgear was when I set up a blocked site or keyword it it would display a nice screen saying "BLOCKED BY NETGEAR FIREWALL" or something like that, with the WRT54G you just get "Connection reset" error. I know its a small thing but can I set up to redirect to a page of my own or something other than the error screen?

  2. Guyfromhe

    Guyfromhe Network Guru Member

    Don't think so, the router just uses the firewall to block it before the connection gets completed so it doesn't actually re-direct traffic or re-generate the page.
  3. Sherwood315

    Sherwood315 Network Guru Member

    Did you ever get an answer or solution to this?
  4. Guyfromhe

    Guyfromhe Network Guru Member

    The answer would be no, it can't be done.
    under any firmware currently.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice