wrt54g as access point

Discussion in 'Cisco/Linksys Wireless Routers' started by Smoky, Sep 23, 2004.

  1. Smoky

    Smoky Network Guru Member

    hi i have 3 wrt54g routers and would like 2 of them to be wireless only access points i will have satori 4.0 firmware on the all 1 of the routers right now is my main router the one that actualy connects to the cable modem the other 2 i just want to be used as access points since the wrt54g seems to cost alot less then the wap54g so i thought id give this a try any idea on how to set them up so that all 3 can connect to the same internet and be able to browse other computers?

    also where these routers will be going there is no way i will be able to run a cat5e wire to them
  2. u3gyxap

    u3gyxap Network Guru Member

  3. Smoky

    Smoky Network Guru Member

    yeah i figured it out but not like his the 2 wrt54g access points are set to AP while the main wrt54g is set to client i had to put the 2 access points in RIP2 router mode didnt mess with WDS at all so far every thing is working although the v2.0 routers seem to crash all the time when i mess with the power settings on the routers where the v1 seems to run just fine and never crashes just need some decent antennas any one know where to get some or have some for sale for these routers?
  4. Smoky

    Smoky Network Guru Member

    the WDS formula seems to work a 1000 times better thanks for the link bro :D
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice