wrt54g as bridge in vpn-environment

Discussion in 'Cisco/Linksys Wireless Routers' started by hennker, Mar 2, 2005.

  1. hennker

    hennker Guest

    Hi there,

    I'd like to connect several not-wireless-capable pcs to the wlan of my university.
    The basic setup for a wireless-equiped pc would be:

    ------- WLAN-AP ::::::::::: My PC

    The Pc would connect to the WLAN, get an IP from the DHCP-Server, but at this point is only able to connect to the vpn-server. all other ips are blocked. I then start the vpn-connection to enable full internet access.

    What I want now is to put the wrt54g in the place of "My PC", so that normal PCs connected per wire to the wrt54g can get an IP from the DHCP-Server from my university, and connect to the VPN-server.

    Is this at all possible? I got the wrt54g to connect to the WLAN with the hyperwrt-firmware, and played around with udhcpc, but I think it would be more transparent if the PCs wouldn't even see the wrt54g.

    Any ideas?

    Thanks in advance,

  2. Guyfromhe

    Guyfromhe Network Guru Member

    the wireless and wired are bridged by default, I don't know if client mode changes this, try turning off the DHCP server on the router and see if that helps...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice