WRT54G Blew up after Firmware upgrade

Discussion in 'Cisco/Linksys Wireless Routers' started by sirsquishy, May 12, 2007.

  1. sirsquishy

    sirsquishy LI Guru Member

    my V5 was running the v23sp2 Micro code, I saw that SP3 was available, tried to install it, the firmware upgrade failed ( the GUI said so ), when the Unit was rebooted ( 2 days later ) it now wont come up.

    PC's get IP's from the range that WRT was giving off, but there is no Traffic going through the 54g, and the GUI is not responsive, same goes for Telnet. and the power light continuously Flashes.

    what the hell happened?
  2. Hackman

    Hackman Network Guru Member

    flash the firmware again with tftp. You should flash 1-2 seconds after the power have been pluged in

    Before that you could try pressind 30sec the reset button
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice