WRT54G Client Mode Help

Discussion in 'HyperWRT Firmware' started by onetonwonton, Apr 9, 2005.

  1. onetonwonton

    onetonwonton Network Guru Member

    I've sifted through so much stuff on this forum but can't figure out what commands I need to put into the start up command list. I want to configure my wrt54g running 2.1 HyperWRT to run in client mode. My current AP is a microsoft mn-700 (I know, it's crappy). I want to be able to run my wrt54g in client mode so I can use it to connect my xbox to my network In short, what commands do I need? (I have WEP) so far all I know is I need wl ap 0 somewhere in there.....

    Right now my gateway is and my subnet mask is
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice