WRT54G client mode setup

Discussion in 'Cisco/Linksys Wireless Routers' started by ssam, Nov 4, 2004.

  1. ssam

    ssam Network Guru Member


    I have a very big problem, and the problem is that i cant get the WRT54G to work as a wireless client (i'd like to connect wired pc-s to the router). Can maybe somebody give a step-by-step howto?
    Must be the router in Gateway or RIP mode? or what?
  2. ssam

    ssam Network Guru Member

    oh, im running alchemy 6.0rc1
  3. u3gyxap

    u3gyxap Network Guru Member

    Just set up the router to work in AP-Client mode in the wireless setup. Make sure you put the same SSID and the MAC address of the AP you connect it to. Then go to Setup --> Basic setup and put the Wireless Setup on Automatic Configuration - DHCP.
    The Router should be in Gateway mode.
  4. ssam

    ssam Network Guru Member

    hmm sory, but it didnt worked for me... Couldnt even ping or anything... It was like the wireless isnt working...
  5. onlybui

    onlybui Guest

    HI Im also trying to put it in Client Mode....

    I have readed that it the Satori firmware doesn't support DHCP and client mode....

    But What I'm trying to do is connect to my friends AP but the problem is that I don't have internet access @ my location....

    So What im trying to do is put the WRT54G into Client mode and try to run kismet on the router and see if there are any open networks in my area...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice