WRT54g Led Lights firmware will not hold need help

Discussion in 'Cisco/Linksys Wireless Routers' started by njemose1, May 5, 2006.

  1. njemose1

    njemose1 LI Guru Member

    I have a wrt54g AMD based Flash chip I managed to brick this router and know semi how to unbrick it the thing is that I manage to short out pin 16 to the xtal1 and i get the diag light to blink fast then slows down but I am able to ping it.

    now comes the odd part how come tftp.exe cannot connect.
    and via command prompt tftp put c:\wrt54.bin will not upload to it times out.

    but for some reason the linksys firmware upgrade utility does work and i see the light flashes then it resets where all the leds light up and the red light goes out and only the power wlan and port 1 light are on but no dhcp and i cant ping it. so if i hit reset it goes back to a solid bricked red diag light. and have to short pins again any ideas before i go postal on this router and line it up to get a slug in it.
  2. njemose1

    njemose1 LI Guru Member

    Disregard this post Managed to fix my wrt

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice