WRT54G problem in client mode

Discussion in 'Cisco/Linksys Wireless Routers' started by Anonymous, Sep 26, 2004.

  1. Anonymous

    Anonymous Guest

    Ok, so i'm a newbie at this. But i went to setup the WRT54G in client mode using hte Sveasoft software, i turned off the DHCP on the client box and changed hte IP address. Now I can't seem to get into the configuration anymore? Can anyone give me tips to be able to get into the configuration? Find out what its ip address is? Or somehow get back to the setup of this client box?
  2. Toxic

    Toxic Administrator Staff Member

    reset your router. press reset button approx for 30 seconds. the router will then default back to its original factory settings of

    username: (leave blank or use root)
    pwd: admin
  3. jdepew

    jdepew Administrator Staff Member Member

    There have been some problems in connecting to the device once it has been switched to client mode, especially through wireless. I had this same problem happen to me when I set up a WRT54GS w/ Satori as a bridge for my SliMP3 player. If you are having problems accessing the router from the network, connect directly to the router as if you were the client connected to it (or administer it from the connected client), you shouldn't have any problem accessing it then.

    While I find that I often can't access the admin except as the clinet, the client mode works just fine. Seems to be a small and known bug in Satori that should be cleared up with the public release of Alchemy.
  4. Smoky

    Smoky Network Guru Member

    yeah ive tryed this befor as well once in client mode you cant get back in it thats why i use WDS now and every thing works perfect :)
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice