WRT54G v2.2 does not boot after flushing image

Discussion in 'HyperWRT Firmware' started by peterwrt, Jan 24, 2005.

  1. peterwrt

    peterwrt Guest


    i'm flashing my WRT54G with current HyperWRT release, but the router
    does not boot.

    The details:

    Linksys WRT54G v2.2 original firmware 3.03.1, 14 October 2004

    The boot_wait flag was on so i did a tftp upload that works
    well always and i am able to upload any image.

    But after power on the power led keeps blinking and the DMZ led
    turns on/0ff each 3 seconds (waiting for tftp).

    It seems no telnet/ssh/http available.

    After that, i try to flush the original firmware from linksys web site (3.01.3) with no success.

    Did you flash this image on this router wirth success ? Is there any incompatible issue ?

    Thank you for your attention,
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice