WRT54G v5 behind Actiontec DSL modem

Discussion in 'Networking Issues' started by immortals, Jul 6, 2007.

  1. immortals

    immortals LI Guru Member

    I am running a WRT54g v5 behind a Actiontec dsl modem. I have the dsl modem running on transparent bridge mode, and the router set on PPPoE connection with the user / pass filled out. I am on the internet via the router on wireless and it is running just fine.

    What I cant seem to get to work though is the port forwarding on the router. I have it set just right (used it for a year over a cable modem perfectly) with the same settings as before. The ports filled out ... to the right computer ... but still receiving "unconnectable/not clever" so I cannot be seen on an outside comuputer. This makes it impossible for me to run an ftp.

    Can you help me figure this out?


  2. frenchy2k1

    frenchy2k1 LI Guru Member

  3. immortals

    immortals LI Guru Member

    that doesnt work, i already know HOW to port forward properly on my wrt54g. I cant however get the modem to go full on into "dummy mode" so it is JUST a modem and not the modem/router. It is on transparent bridge mode ... which should be the modem only mode ... but it cant be because it doesnt forward ports properly.

    any ideas?
  4. immortals

    immortals LI Guru Member

    word, all the sudden it started working properly ... maybe just had to run for like 24 hours :)
  5. immortals

    immortals LI Guru Member

    one other thing though, how do i reset the dsl modem with out it screwing up .... i lost internet today, so i unplugged modem for 1 min, then plugged back in and the DSL light wont stop flashing and no internet ....

    Qwest thinks its on their end, what you think?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice