WRT54GL and Internet LED

Discussion in 'Cisco/Linksys Wireless Routers' started by NeotionBox, Jan 2, 2007.

  1. NeotionBox

    NeotionBox LI Guru Member

    This is my first post, and i want to send hello to all memmbers of this great board.

    I have Linksys WRT54GL Router and one problem, everything is ok with router as i think. Power LED is OK, WLAN LED is OK, Ethernet LED is OK, but when i plug cable from my Cable modem ( Motorola SB5100E ) in it there is no Light on Internet LED, i tryed to change my ethernet cable with new one, also i tryed to reset router, but there is no any change's. I am new owner of this router, and begginer, so should i try to flash my router with some 3rd parity firmware or what to do. Also can somebody point me where i can look how and with what tools to flash my router.

    Thank's to all.
  2. mealto

    mealto LI Guru Member

    Are you plugging the modem into the WAN port or the normal LAN ports?
  3. NeotionBox

    NeotionBox LI Guru Member

    I pluged it in WAN ( Internet Port ) and LED from Internet is not working, but i have success with Ethernet port, when i connect it to ethernet port, is my router dead ?!
  4. unionchurch

    unionchurch LI Guru Member

    Have you looked at the router through its administrative web interface yet?
  5. NeotionBox

    NeotionBox LI Guru Member

    Yap, i was in WEB GUI and there is still all looking good, everything is working but when i plug ethernet cable from my cable modem into WAN Port, Internet LED is not lighing, just i can use internet when i put cable in one of 4 Ethernet port's.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice