WRT54GS 1.1 x2 Client bridge dropouts

Discussion in 'DD-WRT Firmware' started by Oli_FoS, Mar 10, 2007.

  1. Oli_FoS

    Oli_FoS Guest

    I'm running two WRT54GS's both v1.1. One is attached to an ethernet cable modem and the other is in my office.

    I'm running the one in my office in Client mode connected to two PCs, the one near the modem is in AP mode.

    Office: DD-WRT v23 SP2 (09/15/06) std
    Modem: DD-WRT v23 SP1 Final (05/16/06) std

    There's about 30 feet between them and I've set power output on them both to 84mW.

    The problem I've got at the moment is I get the occasional slow down and disconnection between the two boxes. Other than the the system seems to work perfectly.

    I've checked local wifi's and there's no conflicting channels, signal to noise etc read outs from my office WRT read as:

    Signal Noise SNR
    -61 -90 29

    I'm kinda struggling to spot what's causing the slow down and then the dead spot and why it does this irregularly. I do use p2p systems but I've monitored it with these running and disabled and there seems to be no difference.

    Any suggestions guys?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice