WRT54GS 4.71.1 Access Restrictions

Discussion in 'Linksys Official Firmware' started by Seuss, May 9, 2006.

  1. Seuss

    Seuss Network Guru Member

    I have not been able to configure Access Restrictions properly on my WRT54GSv1 since firmware 4.50.6.


    4.50.6 allows you to define up to 10 restriction policies, and the logic is ascending test. That is, if the 1st rules applies, use it, and end. If not, test next rule, etc until last rule (which should be a blanket Block all access).

    I thought there was a bug with 4.70.6, but the same problem persisted in the latest 4.71.1. So now I'm back to 4.50.6 again. Anyone know the process logic for testing restriction policies, please?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice