WRT54GS - How to setup in no NAT mode

Discussion in 'Cisco/Linksys Wireless Routers' started by cuthbei, Sep 4, 2004.

  1. cuthbei

    cuthbei Network Guru Member


    I have just got a WRT54GS and want to set it up in No NAT mode. I'm running the official 2.09.1 firmware.

    I'm connecting to my ISP using PPTP which works fine. I have my registered subnet configured on the LAN side of my router, which works fine as well. As soon as I switch from gateway mode to router mode I loose all access. The diagnostics on the router show it can still PING etc but none of the hosts behind can get access.

    It works fine with other routers, so the ISP setup is fine.

    Any ideas what I'm doing wrong?

    Thanks, Ian
  2. blackomegax

    blackomegax Network Guru Member

    router mode doesnt support WAN's
  3. cuthbei

    cuthbei Network Guru Member

    I found that in the end. So it's not really "router" at all. I'm trying the Sveasoft firmware now but having loads of PPTP issues.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice