Discussion in 'Cisco/Linksys Wireless Routers' started by ulfba, Aug 11, 2005.

  1. ulfba

    ulfba Network Guru Member

    I am trying to get some applications to work properly on the computers in my network.


    Cable modem (86.xxx.xxx.xxx)
    WRT54GX (
    PC1 (

    I have forwarded traffic on port 556 to
    Then I go to the advanced routing tab to try to set up NATing, and this is where I’m lost :sadbye:

    I suppose computer should be
    Subnet mask
    But this is not correct.

    Any sugestions?
  2. 4Access

    4Access Network Guru Member

    The only thing you need to do on the Advanced Routing page to setup NAT is make sure the "Operating mode" is set to "Gateway".

    What exactly is the problem you are having?
  3. ulfba

    ulfba Network Guru Member

    I'm trying to set up DC++ to work in active mode.

    I don't have the option "Operating mode" under NAT.

    Select set number: 1()
    Enter Route Name: DC++
    Destination LAN IP: 192.168 1.30
    Subnet Mask: 255 255.255.0
    Default Gateway:
    Interface: LAN & Wireless WAN(Internet)

    When i try to save settings i get the error message.
    Destination LAN IP address and LAN IP address of the router can not be within the same subnet
  4. 4Access

    4Access Network Guru Member

    You don't need to do anything on the Advanced Routing page! The default settings are what you want. Just set it back to what it was and leave it alone!

    I'm not that framiliar with DC++ but as long as you setup the port forwarding right
    then everything should work.

    If it's not working I'd suggest you double check to make sure you're forwarding all the necessary ports to the correct IP address.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice