Wrt54gx4!! Srx400!!

Discussion in 'Cisco/Linksys Wireless Routers' started by gtodriver_05, Nov 6, 2007.

  1. gtodriver_05

    gtodriver_05 LI Guru Member

    Hey guys i need some help. I have 2 Wrt54gx4 srx400 routers. I want to hook them together, is it possible. I have a 8,000sq house and the signal at the far end from the router is only at 2 bars. I am going to run a 100ft ethernet cable from the 1st router up through the attic and down to the 2nd router. How do i configure the 2nd router so that i can just have one wirless signal, i dont want 2. Is it even possible to connect these 2 together?? PLEASE HELP!! Thanks
  2. Toxic

    Toxic Administrator Staff Member

    You could try using a LAN to LAN (dont use the WAN on the second router) connection between each router, have ones router with DHCP enabled the other without. then have the same SSID, but put both routers on different channels making sure they dont interfere with each other. i.e. Chanel 1 and channel 6 perhaps. you may also need to setup the second router in "router mode" and not gateway mode.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice