wrv200 acting as AP

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by rokec, Jun 17, 2007.

  1. rokec

    rokec LI Guru Member

    Hello guys, hope you can help me out...

    I have an old p200+slackware acting as a router (

    So I purchased wrv200 and I have problems setting it as an AP.
    I set Static IP, changed ip to, subnet, gw and disabled DHCP.
    Which settings do I have to put for LAN IP, since every ip i set it errors with "The IP address falls in the same subnet as your Lan IP address".

    Plz help, I'm out of ideas...

  2. ccbadd

    ccbadd Network Guru Member

    Are you setting the static ip for the WAN port? Just leave the "Internet Connection Type" at Automatic and configure the Lan IP to and you should be fine. You can't use the Wan port if you are using it as an AP.
  3. rokec

    rokec LI Guru Member

    I did just that, I manually entered DNS's, bridged VLAN port 1 to ssid1, and I checked "router" in "Advanced routing.
    Internet is still not working :(

    Am I missing something?
  4. rokec

    rokec LI Guru Member

    Never mind, I've sorted the problem... I don't know how, but it's working now.

    ccbadd, thanks for the help!
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice