I've tried off and on for several months to get a QuickVPN connection to a WRV200 - nothing works. I'm at the point where I need to get it working, or give up and find a different solution. I've been through many firmware versions and a kabillion configurations and settings. Most recently: Firmware: 1.0.24beta Connection: - Connected Win XP Pro PC directly to WAN port on WRV200 (to eliminate possible issues with NAT, port forwarding, etc.) - Static IP on PC (10.5.7.2/255.255.255.0) Changes to default router configuration: - Internet Connection Type: Static IP - IP Address: 10.5.7.1/255.255.255.0 - Domain Name: dummydomain.net - Local IP Address: 10.5.5.1/255.255.255.0 - Time Zone: EST - Wireless: Disabled - DoS Prevention: Disabled - Anonymous Internet Requests: Not blocked - Admin password: Changed from the default - Remote Management: Enabled - VPN: Add Username (testuser), Password (testuser) - (SNMP, Syslog, and UPnP disabled by default) QuickVPN: - version: 22.214.171.124 - port: 443 I shutdown the software firewall and antivirus on the PC. I started an Ethereal capture, and tried the connection. At the "Verifying Network" stage I get a message "The remote gateway is not responding. You will now be disconnected, please try again later". There is no more network activity, and QuickVPN does not respond until I kill it and restart it. I don't really understand the capture log, but I get about 35 frames and nothing jumps out at me (I'll be happy to post if it might help). Any ideas - or - suggestions for a solid product for one or two users to connect to a small business over a broadband connection?