WRV200 Problem connecting DSL (Static IP)

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by GabyCR, Jun 6, 2008.

  1. GabyCR

    GabyCR Addicted to LI Member


    This is my first post in this forum.

    I want to make a VPN connection with 2 WRV200 with firm 1.0.39
    One of the WRV200 is connected to the DSL with PPPoE and work well, but the other WRV200 i can´t connect to the WAN with STATIC IP of TELEFONICA (SPAIN)

    This WRV200 is connected to a thomson speedtouch 510 in bridge mode but they don´t work

    The speedtouch in router mode can connect to internet.

    So I think that the problem is is the STATIC IP configuration, but I try all and I can´t. Someone can help me???

    If you need know something more, please tell me.

    Thank you very much.
  2. Sfor

    Sfor Network Guru Member

    If the SpeedTouch 510 is in the bridge mode, the WRV200 has to provide login and password. So, it will be necesary to set the WRV200 to PPOE, probably. The static IP setting will not do, for sure.
  3. GabyCR

    GabyCR Addicted to LI Member

    I think that the problem is the GATEWAY. Tomorrow i will try
  4. Sfor

    Sfor Network Guru Member

    Well. In the bridge mode, the SpeedTouch 510 will be acting just as a modem. Logging to the provider service has to be done by some other device.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice