wrv200 problem/qos

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by sw1ft, Jul 25, 2007.

  1. sw1ft

    sw1ft LI Guru Member

    I have 1.0.33 firmware now on my wrv200 and I have some problems with this router. First, qos. It is said that I can block upload on 128kbps, 256kbps, 512kbps up to 32M but it starts from 512kbps. I have 4 people in my lan and total upload on modem is 256kbps. I'd like to set 128kbps for each computer in the local network. So this is the first problem. Another problem i connected with qos once again.

    Application-based QoS -> Bandwidth Allocation -> User define

    This option doesn't work. I have an error while I'm trying to save :
    "Unnaceptable first value, 0 is reserved"

    I bought this router only for qos. Its hard to use network while someone else download via p2p so qos is very important thing for me. I know that there was some firmware which allowed user to set upload to 128kbps, but I can't find it. I tried any firmware on this web, but it has 512 and more. If somebody will try to help me, post some link to firmware and staff, I'll be grateful.
  2. sw1ft

    sw1ft LI Guru Member

    can somebody reply? its pretty important
  3. sw1ft

    sw1ft LI Guru Member

    can somebody post previous firmware cause its hard to find it? Please
  4. Sfor

    Sfor Network Guru Member

    I can confirm there are no values of 128 and 256 in the Port based QOS drop menus. According to the help section such a values ought to be there.

    I think, in your case, application based QOS is the only solution, for now. In the user defined bandwidth allocation settings it is possible to use percentage % values, instead of the kbits. In my case the Bandwidth Allocation Advanced Setting table works as expected. Without any error messages.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice