WRV54G Tunnel Issue w/ Dynamic IP

Discussion in 'Networking Issues' started by Scallica, Dec 16, 2008.

  1. Scallica

    Scallica Network Guru Member

    Hello all,

    I have a site to site tunnel configured between two WRV54G routers. Both locations have a dynamic IP, but I configured both routers to use Dynamic DNS. I configured the remote gateway on each router to use the FQDN of the other router. However, when the IP address changes at either location, the tunnel does not automatically rebuild. I have to manually log into BOTH routers and click the disconnect/connect button for the tunnel to be re-established. Does anyone have any thoughts or ideas?

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice