WRVS4400N & Netgear FVS318 VPN

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by Dino 615, Sep 22, 2009.

  1. Dino 615

    Dino 615 Guest

    I am trying to get a VPN established from a Linksys WRV4400 to a Netgear FVS318. I cannot get it to establish a connection. I have gone over the configs 50 times to make sure they match and it will not establish a connection. On the Negear VPN status I get Phase 1: M-MM_SA_WAIT / Phase 2: IDLE and the log shows:

    [2009-09-22 07:19:56]**** SENT OUT FIRST MESSAGE OF MAIN MODE ****
    [2009-09-22 07:19:56]<POLICY: FranklinPtoP> PAYLOADS: SA,PROP,TRANS
    [2009-09-22 07:20:16]**** SENT OUT INFORMATIONAL EXCHANGE MESSAGE ****
    [2009-09-22 07:20:16]<POLICY: FranklinPtoP> PAYLOADS: DEL
    [2009-09-22 07:20:18][==== IKE PHASE 1(to START (initiator) ====]
    [2009-09-22 07:20:18]**** SENT OUT FIRST MESSAGE OF MAIN MODE ****
    [2009-09-22 07:20:18]<POLICY: FranklinPtoP> PAYLOADS: SA,PROP,TRANS

    It just keep going through that and never connects. I am sure it is probably a simple problem on the Linksys config that I am not matching up, but any help with issues between the two brands is greatly appreciated.

  2. Wrsv4400n to fvs318

    Did you resolve the connection issue. can you please post your settings, I am running into similar issues with the same routers? thanks
  3. DocLarge

    DocLarge Super Moderator Staff Member Member

    What's the firmware you're running on the wrvs4400n?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice